What you need:
- Straw-McDonalds and Burger king have a fairly good size. You want it thick
- Silicon-10 oz should be more than enough
- Funnel-For making the part that rests against your skin, If you have a men's cup that'd work even better
- Scissors
- Ziplock Bags
- Acrylic Paint-Either your skin color or correct colors to mix it
- Plaster- or some kind of molding material to make the form of the dick, you could always mold it fre hand but this comes out nicer
- Duct Tape
- Cardboard Box
- Ping Pong Balls- Recommended, not mandatory
- Straight Razor
- Plastic Cup/Dish
- Brush
- Paper Towels
- Wires
I. What you want to do first is to anchor the
Straw to the
Funnel/Cup using
Duct Tape. making it nice and tight you want to angle the straw on a downward slope. Next, if you decided to buy the
Ping Pong balls, you want to use a straight razor to cut one in half. Place the two halves below the straw, tape them, these will be the mold for the Testicles.
II. Next you want to empty out the contents of the
Silicon tube into a small
dish/plastic cup. Using a
brush start coating the form with the
silicon, you want to get it to about a quarter inch on all sides smaller then you want it to be. Let it dry standing up on the
Funnel/Cup in a
Cardboard box, Over night should be a long enough time.
III. Make your skin colored
Silicon using the
Acrylic Paint and left over
silicon. This video will show you how->
IV. Now I went about it by creating a mold of a dick by using a paper towel tube(a thin one),
ping pong balls in
nylon,
wires,
duct tape,
paper towels and imagination. I taped wires to the inside of the tube running them to the other side as if they were veins, not taught and straight. I split some wires to make it more realistic. Fashioning the tip out of paper towels I wrapped the tube ad tip in duct tape so the wires didn't stick out too much. I then taped the ping pong balls i put in nylon to the end so they were hanging down and let that to dry in the plaster. You could always go and put the skin colored silicon on free hand, if so, good for you, you can also take a mold of a regular packer if you have one. Cutting open the plaster, take out the tube.
V. Coat the sides of the mold in the skin colored silicon and place your mold in and close it. Don't worry about silicon spilling over you can trim that off later.
Notes: I used mold release to remove the straw and such quite easily, I am not sure how to do this without mold release, best of luck <3
